Editor’s note: Please welcome Evail Juan to Planandprepared.com. He will be a regular here, providing reviews on firearms, firearm accessories and tools, as well as other prepper related gear.
I recently received a Magpul Enhanced Trigger Guard as a gift (Thanks Sis). But upon reading how to change it out from the Mil Spec guard, I was shocked to learn the suggested method was to get an armorers block, roll pin punch, and a mallet to hammer the pins out. That being said, there is a disclaimer that should read “If you break the tab off, your lower will be JUNK!”
In this day and age why wouldn’t there be an easier way to change this out without the chance of destroying the lower receiver? Enter the Wheeler Trigger Guard Installation Tool. This tool is basically a specialized C-Clamp with 2 rods included. The long rod is for the removal, while the short rod is for the install. I actually read the directions carefully, which were precise and to the point.
The removal and install took about 30 minutes to complete. The only reason that took a little longer than expected was because I aligning the pin and install tool to start the pin into the hole. Seems like a third hand would be nice here for this process. But with a little tongue waggling, a few choice words, and a bit of patience I was able to get it to fit.
Once I was able to get it aligned into the hole, then it was just a simple matter of making sure the pin was flush with the receiver. Then voila, the change was complete!
All in all I would give the Wheeler Trigger Guard Install Tool a 4.75 stars. And the only reason I’m not giving 5 stars is due to the fact that holding all the components and trying to get it aligned was not an easy task.
